Skip to content

How ZARC works

ZARC IoT data network topology

We supply the complete system end to end, and the ZARC IoT data network carries its readings one way: from battery-powered tags, over 433 MHz radio, to a ZARC Gateway, and on to the IoT Technologies platform over an encrypted, zero-trust private network. This page sets out the topology end to end, from the tag on your equipment to the alert on your phone, and why every tag is built to send and never to receive.

01

One-way communications by design

A ZARC tag transmits and never receives. That one decision is what makes the tags secure, long-lived and quick to report, and it is deliberate.

Security

A ZARC tag has no receiver. There is no pairing, no remote configuration interface and no inbound radio path, so there is nothing on the tag to log in to, command or take over.

Battery life

Listening is what drains a battery sensor: a receiver has to wake and wait for messages that rarely come. A ZARC tag's radio is off except for the moment it sends, so its energy goes on a few short bursts. That is how a tag runs up to five years as standard, and longer with more cells.

Efficiency

With no handshakes, acknowledgements or polling, each message is a single short transmission. The channel stays clear, so one gateway serves a large number of tags, and every gateway in range hears every tag.

Speed

There is nothing to negotiate before a tag sends. An event, such as a door opening or a pressure switch closing, goes out the moment it happens and typically reaches the dashboard within a second.

One-way is the right design for monitoring and alerting. ZARC watches equipment and reports on it; it never sends commands back into your site. Because the tags take no instructions, nothing can reach your equipment through them, and your kit cannot be controlled through the monitoring layer. That substantially reduces the cyber risk a monitoring system adds to a site.

02

How a reading travels the ZARC IoT data network

Illustrative ZARC IoT data network topology: tags across a building send one way over 433 MHz to a ZARC Gateway, which reaches the IoT Technologies platform over an encrypted private network by cellular, Wi-Fi, Ethernet or satellite.
Illustrative.

Your site

Battery-powered tags fit to the equipment you already have: cylinders, doors, tanks, panels, plant and rooms. Each one reports over 433 MHz to a ZARC Gateway, up to 5 miles line of sight in good conditions, and the radio is chosen for its reach through walls, floors and metal. Add gateways for reach and redundancy; every gateway in range hears every tag, and the platform keeps the strongest signal, so nothing is duplicated.

Backhaul

The gateway is the one powered element on site, with battery backup available. 4G is standard, with 5G and 2G where the network offers them. Wi-Fi and Ethernet are used where the site has them. Where nothing else reaches, the gateway connects by satellite: Starlink as standard, or Inmarsat or Globalstar where required. Whichever route a site uses, the traffic runs inside an encrypted, zero-trust private network from the gateway to the platform.

Platform

Traffic arrives through a firewalled, secure ingest. The platform decodes every report, de-duplicates it, checks it against your limits, watches that every tag checks in, and keeps real-time and historical telemetry for compliance and audit, for as long as you need it. It is written, hosted and run by IoT Technologies, on our dedicated servers, your own servers, servers on site, or in the cloud, whichever suits you.

Dashboard and alerts

The dashboard shows every site live and sends alerts by SMS or email to the people you choose, with escalation if an alert is not acknowledged. API handoff passes the same data to your BMS, CMMS or ERP.

03

When a tag reports

  • Events, the moment they happen.

    An event tag sleeps until there is a discernible change of state: a door opens, a contact closes, water bridges the pins, power is lost. It wakes, sends at once, and the dashboard raises a real-time alert.

  • Readings, on your interval.

    A reading tag reports a value, such as temperature, pressure or level, on an interval you set: every minute, every 5, 10 or 20 minutes, or whatever the job needs. A shorter interval gives finer detail; a longer one gives longer battery life. We set the balance with you for each application.

  • Check-ins, so silence is never mistaken for calm.

    Every tag also checks in on a schedule. If a check-in does not arrive, the dashboard raises an alert, so a tag that has been damaged, removed or blocked is known about straight away.

04

Inside a ZARC tag

Illustrative diagram of a ZARC tag on the ZARC IoT data network: a sealed IP68 enclosure holding the sensor, a 433 MHz radio and batteries, and the six steps from sensing a change to an alert on the dashboard.
Illustrative.

Every tag is a sealed IP68 enclosure, UKCA marked, holding the sensor, the 433 MHz radio and its batteries. Nothing is needed at the point of measurement: no mains and no data cabling. Each tag senses, sends one short burst to the ZARC Gateway, then goes back to sleep.

05

Security at every layer

The tag
Transmit-only, with no receiver, so there is no remote path into it.
The radio link
Short one-way bursts at 433 MHz. Every gateway in range hears them, and a tag that stops being heard raises its own alert.
The gateway
The one powered element on site. It reaches the platform only through the encrypted private network, and the platform raises an alert if a gateway stops reporting.
The network
An encrypted, zero-trust private network on every backhaul route, from the gateway to the platform.
The platform
Firewalled, secure ingest with zero-trust access, hosted where it suits you, with every reading, alert and acknowledgement kept as a timestamped record.
06

Designed around your requirement

The ZARC family of tags covers most sites as ready form factors: pressure, temperature, door state, water leak, power failure, dry contact and many more, built to order for each project. Where a site needs something different, we adapt a form factor or design a new one, and the dashboard is configured around your estate.

If you have a sensor or an application in mind, talk to us. We will design the best solution for it.

Questions we answer most.

Can a ZARC tag be hacked remotely?

No. A ZARC tag has no receiver, so there is no remote path into it: nothing to log in to, no settings to change and nothing to command. If a tag is ever stopped from being heard, the check-in it was due to send does not arrive, and the dashboard raises an alert.

If a tag cannot receive, how is it set up?

Each tag is set up for its job before it is installed: what it measures, how often it reports and how often it checks in. Limits, alert rules and who receives each alert live on the platform, so they can be changed at any time without touching the tag.

What happens if a gateway stops working?

The platform raises an alert when a gateway stops reporting. Where a site has more than one gateway, every gateway in range hears every tag, so the others carry on.

Is the connection from site to platform secure?

Yes. Whichever backhaul the gateway uses, cellular, Wi-Fi, Ethernet or satellite, the traffic runs inside an encrypted, zero-trust private network and arrives at the platform through a firewalled, secure ingest.

Where is our data held, and for how long?

Wherever suits you: on our dedicated servers, your own servers, servers on site, or in the cloud. Real-time and historical telemetry is kept for as long as you need it, for compliance and audit.

Can the data go into our own systems?

Yes. API handoff passes readings and alerts to your BMS, CMMS or ERP, alongside the dashboard.

How far does the radio reach?

Up to 5 miles line of sight in good conditions. Real range depends on walls, metal and terrain, so it is confirmed by a site survey, and more gateways extend coverage.

Further reading

Talk to an engineer.

Ask the people who designed and built it. No obligation.

Location

Venator House, Unit 9, 15-17 St Stephen's Road, Bournemouth

Dorset, BH2 6LA · VAT GB 409644484

Tell us about your enquiry

Provide a few details about your sites, assets and operational needs. We will be in touch to discuss the right approach.

We'll only phone you if you choose phone as your preferred contact.

Preferred contact (optional)

Optional. Leave blank and we reply by email.

No mailing lists. No spam. We reply directly to your enquiry.